Guides · Materials
Material properties in engineering calculations: sources and your own data
Library values and their sources, typical versus design values, and one material worksheet included everywhere.
Almost every engineering calculation starts from material properties: a yield strength, a modulus, a density, a thermal conductivity. Where those numbers come from matters as much as the formulas, because a reviewer will ask. This guide covers the two ways to get material data into a Swift Calcs worksheet, and how to keep your own values in one place so every calculation uses the same, checked numbers.
The built-in material library
Insert a Material Library line from the toolbox, search for a material and pick it, then give it a name, for example Al. Read its properties with a colon: Al:density, Al:elasticModulus, Al:proofStrength, or the short forms Al:rho, Al:E, Al:sigma_y. Depending on what the source lists for that material, you get density, elastic and shear modulus, Poisson's ratio, tensile and proof strength, thermal conductivity and expansion, heat capacity and electrical conductivity. Units come with the values, so they convert like any other quantity.
- Solids (metals, plastics, ceramics) come from MakeItFrom.com. They are typical values for the material family, not guaranteed minimums for a particular product form, temper or thickness.
- Gases and mixtures (the Ideal Mixtures line) use the thermodynamic data of the NASA Glenn Research Center. Each substance's data is valid between the minimum and maximum temperature shown when you pick it; stay inside that range.
The source is printed under each material line, so it appears on the printed or PDF calculation too. Typical values are right for concept work, comparisons and sanity checks. For a design check that someone will sign, use the value your supplier guarantees or the one the governing standard specifies, and say which.
Your own material data, in one worksheet
Most companies use a short list of materials again and again, with design values taken from a standard, a datasheet or a test report. Keep them in one worksheet and pull them into every calculation:
- Make a worksheet called, for example, "Material data". Write one line per value, with a clear name and its unit, for example
S355_fy = 355 MPa,S355_E = 210 GPa,Al6061T6_fy = 240 MPa. - Write the source next to each group in a text line: the standard and edition, the datasheet and its date, the thickness range or temper the value applies to. This is what a checker reads.
- In any calculation, insert an Include Worksheet line from the toolbox, choose "Your Worksheets", pick the material worksheet and tick the variables you need. They behave exactly as if they were typed in that sheet. (On the free plan an include brings in up to two variables.)
- Change a value once. When a standard is revised or you change supplier, edit the value in the material worksheet, then reload that worksheet once so it recalculates in full and saves the new values. Every sheet that includes it picks up the new value the next time it is opened, or straight away with the refresh link on its include line.
Share the material worksheet with your team (read-only is enough) so everyone includes the same file. The same approach works for bolt grades, standard sections, safety factors and any other company data.
Common mistakes
- Using a typical value as a design value. Typical tensile strength is often well above the specified minimum. Check which one your method needs.
- Ignoring temperature. Strength and modulus fall with temperature; the library values are at room temperature.
- Ignoring thickness or temper. The yield strength of structural steel and of aluminium alloys depends on thickness and temper. Name the condition in the variable or the text next to it.
- Copying values between sheets. A copied number does not update and loses its source. Include it instead.
Questions
Can I see where a library value comes from?
Yes. The source is shown under the material line in the sheet and on the printout. For the full data of a solid material, look it up by name on MakeItFrom.com.
Can I add my own materials to the library?
Not to the shared library. Use a material worksheet as described above: it does the same job and keeps the source of every value visible.
